Vogel: Cat's Paws and Catapults
From Scienticity
m |
|||
| Line 10: | Line 10: | ||
Here at Ars Hermeneutica we look favorably upon any book in any subject that exhibits an analytical approach to its subject, so that it may serve as an example. ''Cat's Paws and Catapults'' has it in profusion. Barely a sentence goes by without some perceptive analysis. Here, for instance, is a comparative discussion of stiffening plates, in natural and human technology: | Here at Ars Hermeneutica we look favorably upon any book in any subject that exhibits an analytical approach to its subject, so that it may serve as an example. ''Cat's Paws and Catapults'' has it in profusion. Barely a sentence goes by without some perceptive analysis. Here, for instance, is a comparative discussion of stiffening plates, in natural and human technology: | ||
<blockquote> | <blockquote> | ||
| - | When it comes to stiffening flat plates with a minimum of material, nothing touches insect wings. | + | When it comes to stiffening flat plates with a minimum of material, nothing touches insect wings. Insects commonly invest only about 1 percent of body mass in their wings. Yet the wings move at several meters per second through the air, and many reverse their movement several hundred times each second. To get sufficient stiffness for this demanding application, they combine curvature, veins, and lengthwise pleats. Curvature may be an aerodynamic necessity in all but the very small insects, but it presents a special problem for beating wings: The direction of curvature that's right for a downstroke is wrong for an upstroke. Many insects have a fine solution: Their wings are built so they're curved by the force of the wind that strikes them. Since the wind on the wings reverses between upstroke and downstroke, their curvature reverses too. |
<br><br> | <br><br> | ||
Thin, flat surfaces deflect with even small loads. The rounded shapes of our automobiles seem made for minimizing drag and wind noise and for maximizing sales appeal—the latter perhaps by tacit allusion to well-curved human bodies. In fact, the roundness of cars serves primarily to stiffen them, if more attractively than folds or ripples. Pressing a piece of metal into a curved shape is much simpler and uses less material than spot-welding a lot of stiffening strips to a plate. Sometimes we use a cruder fix; heating ducts are most often rectangular in cross section, so they form huge arrays of thin, flat, metal sheets. Minor changes in pressure or even temperature all too easily bow these sheets sideways and produce disconcerting noises. We minimize the problem (but don't fully fix it, at least in my house) by putting slight diagonal creases in the flat surfaces. [p. 62] | Thin, flat surfaces deflect with even small loads. The rounded shapes of our automobiles seem made for minimizing drag and wind noise and for maximizing sales appeal—the latter perhaps by tacit allusion to well-curved human bodies. In fact, the roundness of cars serves primarily to stiffen them, if more attractively than folds or ripples. Pressing a piece of metal into a curved shape is much simpler and uses less material than spot-welding a lot of stiffening strips to a plate. Sometimes we use a cruder fix; heating ducts are most often rectangular in cross section, so they form huge arrays of thin, flat, metal sheets. Minor changes in pressure or even temperature all too easily bow these sheets sideways and produce disconcerting noises. We minimize the problem (but don't fully fix it, at least in my house) by putting slight diagonal creases in the flat surfaces. [p. 62] | ||
| Line 43: | Line 43: | ||
[[Category: Book Notes]][[Category: Top-Rated Books]] | [[Category: Book Notes]][[Category: Top-Rated Books]] | ||
| + | [[Category: JNS]] | ||
